| Basic Use |
| CA3600 provides multi-purpose versatility, far exceeding the adhesive requirements of the American Plywood Association's AFG-01 Specification for Subfloor Applications. CA3600 provides excellent bonding for a myriad of construction applications including: subfloors, furring strips, paneling, drywall and cultured marble. CA3600 is easily applied and cleans off with water when uncured. |
 |
| Shelf Life |
| CA3600 has a shelf life of 2 years from the date of manufacture when stored at temperatures from 40°F to 90°F. Expiration date is stamped into each tube. |
|
| Limitations |
| Hilti CA3600 is not recommended for use on: |
|
|
| 6.4.1.4 INSTALLATION INSTRUCTIONS |
 |
|
|
| Surface Preparation |
| All surfaces should be clean and free from all contaminants such as oil and grease. |
|
| Installation |
| Place adhesive cartridge in dispenser and cut tip at slant to desired bead diameter. Puncture inner seal with nail or wire and apply adhesive in a continuous bead. Press the surfaces firmly together. Large applications may require bracing until adhesive has set.
When using on glued floor systems, follow APA guidelines for applying adhesive. Note: Store adhesive at room temperature for 24 hours prior to use to allow proper extrusion when application involves temperatures below 40°F. |
|
| Cleaning |
| Tools and excess adhesive may be cleaned with water while adhesive is in an uncured state. Dried adhesive can be removed with scraper. |
